WILI COMPANY LIMITED HAS BEEN AWARE OF ISO 9001:2015 CERTIFICATION
- Details
ISO 9001:2015
Established in the early days of July 2014, after 7 years of establishment and development with the policy and orientation of sustainable development from the beginning, the Board of Directors of Wili Company Limited and all employees Members were unanimous, determined to build a solid foundation from the first steps by successfully implementing the quality management system according to the international standard ISO 9001: 2015 and the results from that determination. was realized by last July 5, 2021 – right on the occasion of Wili's 7th birthday. Wili Limited Liability Company was honored to receive ISO 9001:2015 certification issued by Vietnam Certification Joint Stock Company for the scope of activities:
“Trading in valves of all kinds and heating and cooling equipment./.”
Read more: WILI COMPANY LIMITED HAS BEEN AWARE OF ISO 9001:2015 CERTIFICATION
Selection of explosion protected equipment for hazardous locations-hazadous-zone-t1-t2-t3-t4-rate-zone0-zone-1-zone-2-zone-3
- Details
Selection of explosion protected equipment for hazardous locations-hazadous-zone-t1-t2-t3-t4-rate-zone0-zone-1-zone-2-zone-3
All workers in hazardous locations must be declared competent to express their opinions in compliance with the Electrical Machinery Regulation (EMR). Human error or incompetency has been found to be at least one part of the domino effect in major disasters.
All hazardous locations must comply with the Occupational Health and Safety (OHS) Act, as well as with the relevant codes of practice and standards. Section 9 of the Electrical Machinery Regulation (EMR) requires that all hazardous areas be classified and equipment used in such areas be certified. All explosion protective equipment (EPE) must be certified by a locally-approved test laboratory (ATL), as required by regulation ARP 0108. Workers in hazardous locations must receive proper Ex training and be declared competent.
A fire or explosion can only occur if three things are present: fuel, oxygen and an ignition spark. The required ratio of fuel and oxygen varies with each fuel (gas or vapour). Suppressing or separating one or more of these three components can avoid a fire or explosion.
Read more: Selection of explosion protected equipment for hazardous...
TEC- Thermoelectric cooler
- Details
TEC / Peltier Element Design Guide
TEC controllers are used for thermoelectric cooling and heating in combination with Peltier elements or resistive heaters. Peltier elements are heat pumps which transfer heat from one side to the other, depending on the direction of the electrical current. TEC controllers are used to drive the Peltier elements.
This system design guide provides information about how to design a simple thermoelectric cooling application using TEC controllers and Peltier elements. When designing a thermoelectric application, cooling is the critical part. So, we will take the case of cooling an object as example for the design guide.
WILI - DATA SHEET
- Details
Dear Value Customer,
Please click here
1/ HEAT EXCHANGER >>
2/ HEATING PRODUCTS >>
3/ WILI PROFILE >>
4/ WATER VALVE >>
Types of Valve End Connections
- Details
Threaded Connections
Threaded connections are very common. They provide a compact and streamlined connection between the valve and pipe.
The valve typically has female threaded end connections, into which the male threaded pipe fits. There are valves with male threaded connections as well, and even valves with one female end and one male end. Threaded connections must adhere to a standard in order to be useful in industry. There are a few different standards that exist. The valve and pipe must both be created using the same standard in order for them to make a proper connection.